Description

STM32F103C8T6 small system board MCU core board STM32 development board learning board ARM

 

STM32F103C8T6 Core Board (Immersion Gold Version)

Warm Tip: Pin headers are included, but soldering is not required!

Each STM32F103C8T6 development board comes pre-programmed with a test program. Upon power-up, the LED will flash evenly to verify that the board is functioning properly.

Full documentation link: http://pan.baidu.com/s/1o7KcYIA Password: x8f4 (circuit diagrams provided)

Core: ARM 32-bit Cortex™-M3 CPU

− Up to 72MHz operating frequency

− Single-cycle multiplication and hardware division

Memory

− 64K or 128K bytes of flash program memory

− Up to 20K bytes of SRAM

Clock, reset, and power management

− 2.0-3.6V power supply and I/O pins

− Power-on/power-off reset (POR/PDR), programmable voltage monitor (PVD)

− 4-16MHz crystal oscillator

− Built-in factory-trimmed 8MHz RC oscillator

− Built-in calibrated 40kHz RC oscillator

− PLL for CPU clock generation

− 32kHz RTC oscillator with calibration

Low power consumption

− Sleep, Stop, and Standby modes

− VBAT powers the RTC and backup registers

Two 12-bit analog-to-digital converters with 1µs conversion time (up to 16)

− Conversion range: 0 to 3.6V

− Dual sample and hold function

− Temperature sensor

lDMA:

− 7-channel DMA controller

− Supported peripherals: timers, ADC, SPI, I²C, and USART

l Up to 80 fast I/O ports

− 26/37/51/80 I/O ports, all of which can be mapped

16 external interrupts; nearly all ports are 5V tolerant

l Debug mode

− Serial Single Wire Debug (SWD) and JTAG interfaces

l Up to 7 timers

− Three 16-bit timers, each with up to 4 channels for

Input capture/output compare/PWM or pulse counting, and incremental encoder input

− One 16-bit PWM advanced control timer with dead-band control and emergency brake for motor control

− Two watchdog timers (independent and windowed)

− System timer: 24-bit countdown counter

Up to 9 communication interfaces

− Up to two I²C interfaces (SMBus/PMBus support)

− Up to three USART interfaces (ISO7816, LIN, IrDA, and modem control support)

Up to two SPI interfaces (18Mbit/s)

− CAN interface (2.0B active)

− USB 2.0 full-speed interface

CRC calculation unit, 96-bit unique chip code

Shipping: 1 mainboard (pin headers included, no soldering required)